This is an old version of documentation. You are welcome to visit our new help center. Open.

Map

On the Map tab, you can see the location of all units from the worklist.

In addition to the same-name tab, the map is available in the properties of the unit, its history, and on the Geofences tab. You can find the information about the map settings here.

Map Selection

To select a map, tap the icon in the upper left corner, make a selection, and tap OK. You can also do this on the Settings tab (the Map source option).

Working with the Map

You can zoom and rotate the map. Besides, you can use it to find your own location.

Zooming

Zooming the map is possible using the buttons (the Zoom buttons option must be activated in the settings) or special gestures:

• double tap or spread to zoom in;
• single tap or pinch to zoom out.

Map rotating

Map rotating is possible using a rotation gesture with two fingers. To return the map to its original position, tap the compass icon.

Finding your own location

To find your own location on the map, tap the icon . As a result, the map focuses on the location of the mobile device, and the icon turns blue. When you move around the map and lose the location marker, the icon changes to , tapping which centers the map on the location of the mobile device.

Map Menu

The map menu is available after a long tap on the map. The menu contains the following items:

• Create geofence (see the Creating geofences section);
• Navigate to.

Route planning

A tap on Navigate to in the menu opens a list of the navigation applications installed on the device. Select the required one to plan a route.

The navigation application automatically uses the point you have tapped on the map as the endpoint of the route. The starting point is the location of the mobile device.

Units on Map

By default, the map is centered so that you can see all units on the screen. To quickly find the unit, use the dynamic search.

To view extended information about a unit, tap its icon. Tap the icon again to center the map on the unit and update the data from the General information and History blocks.

The icons overlapping each other can be replaced by a common icon with a numerical indicator (the Icon grouping option). The indicator shows the number of grouped units. Tap the icon to see the list of the units.

If there are more than 100 units in the worklist, the Icon grouping option is enabled automatically when you open the map.

If the Unit movement direction layer is activated in the web version of Wialon and the Unit icons option is enabled in application settings, the unit movement direction is shown next to the unit icon on the map.